Inspection and Operation of the Nail Clamping Dies on High Speed Nail Making Machine
This machine is designed with double dies and double punches, which has the advantage of forming the nail head twice, ensuring the concentricity and roundness of the nail head. Compared with traditional machines, the ratio of the nail head diameter to the nail shank diameter is larger in this model.
1. The nail die specifications and wire diameter must match.
2. Nail dies must be used in pairs.
3. For easy debugging, install the lower nail die first (distinguish between the main and auxiliary nail dies). Adjust the "nail die transmission rod" to the engaged state. Adjust the left and right positions of the "nail die seat" to ensure that the clamping groove of the nail die is aligned with the center of the nail shank. Tighten the "nail die seat fastening bolts". Then adjust the up and down position of the nail die until it just slightly lifts the nail shank. Tighten the "nail die pressure plate bolts" and "nail die top tightening bolts".
4. Install the nail mold (distinguish between the main and auxiliary nail molds). Adjust the "nail mold drive rod" to the engaged position. Adjust the left and right positions of the "nail mold seat" to ensure the clamping groove of the nail mold is aligned with the center of the nail rod. Tighten the "nail mold seat fastening bolts." Then adjust the up and down position of the nail mold, ensuring clear clamping marks on the nail rod. Adjust the "nail mold drive rod" to the open position and tighten the "nail mold pressure plate bolts" and "nail mold top tightening bolts."
5. When changing the nail mold, if the wire diameter is not changed, the auxiliary nail mold does not need to be replaced.
Note: All bolts on the nail mold seat must be tightened before starting the machine.







