This machine has 3 types of synchronous belts: the main synchronous belt HTD14-2562, the "feeder" synchronous belt HTD8-736, and the nail feeding synchronous belt 25-AT5-2000.
When replacing the synchronous belt, it is crucial to ensure that the tooth profile of the synchronous belt and the initial drive angle of the drive pulley are consistent with this instruction; otherwise, it will severely affect the nail production quality and may even result in batch scrap.
Main Synchronous Belt HTD14-2562 Replacement Instructions
1. First, crank the "manual wheel assembly" to rotate the "wire feeding eccentric flange" to the appropriate position, ensuring the notch is vertical and on the right side;
2. Loosen the tensioning pulley inside the "reverse limiting box assembly" and adjust the synchronous belt position appropriately;
3. Ensure the groove of the "straight shaft large synchronous belt pulley keyway" is in a horizontal position, then tighten the tensioning pulley inside the "reverse limiting box assembly".
Replacement Instructions for HTD8-736 Nail Feeder Synchronous Belt
1. First, rotate the "Straight Shaft Small Synchronous Pulley" until its keyway is horizontal;
2. Then, rotate the "Nail Feeder Synchronous Pulley" until its keyway is vertically downward;
3. Finally, tighten the "Synchronous Belt Tensioner," ensuring that the keyway position of the synchronous pulley mentioned above has not changed.
